CAUTION: Always ground yourself to remove any static charge before touching the motherboard, backplane, or add-on cards. Sensitive electronic components can be damaged by sudden power surges.Ģ0. Do not make connections while the power is on. CAUTION: Always completely disconnect the power cord from your chassis Operation is subject to the following two conditions:ġ) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that This device complies with Part 15 of the FCC rules. THE COMPUTER IS PROVIDED WITH CD DRIVES COMPLY WITH APPRO-PRIATE SAFETY STANDARDS INCLUDING IEC 60825.ĬLASS 1 LASER PRODUCT KLASSE 1 LASER PRODUKTġ8. Discard used batteries according to the manufacturers instructions.ġ7. Replace only with same or equivalent type recommended by the manufacture. There is a danger of explosion if battery is incorrectly replaced. CAUTION: The computer is provided with a battery-powered real-time clock cir-Ĭuit. f) The equipment has obvious signs of breakage.16. e) The equipment has been dropped and damaged. d) The equipment does not work well or you cannot get it to work according to c) The equipment has been exposed to moisture. b) Liquid has penetrated into the equipment. Personnel: a) The power cord or plug is damaged. If any of the following situations arises, get the equipment checked by service Opened only by qualified service personnel.15. For safety reasons, the equipment should be This could cause fire or electri-Ĭal shock.14. Never pour any liquid into ventilation openings. If the equipment is not used for long time, disconnect it from the power source toĪvoid being damaged by transient over-voltage.13. All cautions and warnings on the equipment should be noted.12. The voltage and current rating of the cord should be greater than the voltage and current rating marked on the product.ġ1. Do not place anything over the power cord. Place the power cord such a way that people can not step on it. Make sure the voltage of the power source is correct before connecting the equipment to the power outlet.ġ0. The openings on the enclosure are for air convection hence protects the equip-ment from overheating. Temperature under 0C (32F) or above 40C (104F), it may damage the equip-ment.Ĩ. Do not leave this equipment in an environment unconditioned where the storage
Put this equipment on a reliable surface during installation. Keep this equipment away from humidity.6.
For pluggable equipment, the power outlet shall be installed near the equipmentĪnd shall be easily accessible.5. Disconnect this equipment from AC outlet before cleaning. Keep this user manual for later reference.3. Read these safety instructions carefully.2. 2002061061 Edition 3Printed in China February 2009
All other product names or trademarks are theproperties of their respective owners.įor technical support and service, please visit our support website at: reserves the right to make improvements in the products described in thismanual at any time without notice.No part of this manual may be reproduced, copied, translated or transmitted in anyform or by any means without the prior written permission of Advantech Co., Ltd.Information provided in this manual is intended to be accurate and reliable.
#Ipc 610 manual español software
CopyrightThis documentation and the software included with this product have been copy-righted by Advantech Co., Ltd.